The non-reciprocating cocking handle is located above the handguard and protrudes from the cocking handle tube at approximately a 45° angle. This rigid control is attached to a tubular piece within the cocking lever housing called the cocking lever support, which in turn makes contact with the forward extension of the bolt group. It is not however connected to the bolt carrier and therefore cannot be used as a forward assist to fully seat the bolt group. The cocking handle is held in a forward position by a spring detent located in the front end of the cocking lever support which engages in the cocking lever housing. The lever is locked back by pulling it fully to the rear and rotating it slightly clockwise where it can be hooked into an indent in the cocking lever tube.
Since you can only install this software on Windows or Mac, you may need a USB drive to store downloaded movies. Therefore, you need to change the default output path to a USB stick. Before that, make sure it is plugged into your computer and recognized successfully. Then, click on the three-dot icon in the upper right corner and select the "Settings" option. In the pop-up window, select the "Save video to" box to browse and set the output directory to USB. 2b1af7f3a8